UST116R UTP CAT5 Video Receiver is an active (amplified) device that allows the extension of real-time monochrome or color video on up to 4000ft ,using Category-5 Unshielded Twisted-Pair (UTP) CAT5 networking wire. Baseband (composite, PAL/NTSC/SECAM) signals of any type are supported.
The unparalleled interference rejection and low emissions of the Model UST101T UST104T & UST104R UST104R-2 UST108R UST108R-2 UST116R allows long run video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the use of shared or existing cable plant. Ground-lifting ensures no annoying "hum-bars" when ground potential differences exist. With built-in lightning protection,transient protection, ESD protection,damaging voltage spike problems are eliminated.
Cable Distance：Up to 4000ft, UST101T(or UST104T)+UST108R UST116R/UST116R-F UTP CAT5 or better
The transmission of real-time PAL, NTSC or SECAM video signals.
Image figure enhanced in output of UST116R/UST116R-F Receiver.
Lightning protection, Transient protection, ESD protection, damaging voltage spike problems are eliminated
Dimensions no excluding BNC: Standard 19" 1U Metal Rack Housing.
Frequency Response DC to 6 MHz
Distance Switch 4-Position Adjustable
for each channel.(UST116R)
Single Potentiometer for Brightness & Sharpness control.
Common-mode / Differential-mode Rejection 15KHz to 5 MHz 60 dB typ
Coax, female BNC 75 ohms.
UTP, Terminal Block/RJ45Jack 100 ohms
Network Wiring 2 Unshielded Twisted Pair 24-16 AWG (0.5-1.31mm)
Category Type Cat 5 or better
Impedance 100 ± 20 ohms
DC Loop Resistance 52 ohms per 1,000 ft (18 ohms per 100 m)
Differential Capacitance 19 pF/ft max (62 pF/m max)
Power On Red Indicator Light
Power Supply Range
16Channel Active Receiver:
Temperature 0°C to +50° C
Humidity (non-condensing) 0 to 95%
6,000 V 1.2μS x 50 μS per ANSI/IEEE 587 C62.41 B3
.3,000 V 8μS x 20 μS when ground screw terminal is bonded to earth-ground
1:Put the video signals you need in the VIDEO IN of UST101T (or UST104T).
2: Put a twisted-pair in the each channel VIDEO A, B of UST116R/UST116R-F
3: Connect with the mains following instructions shown in the sketch map, make sure that the power should be 220V/AC power range (Can be designed as 110V/AC).
Recommend to share 12V DC power supply with camera in transmitter termination.
4: Set the position of ADJ (or Potentiometer - UST116R-F) correctly according to the distance table in UST101T(or UST104T) & UST116R or UST101R UST101R-2 UST104R UST104R-2 UST108R UST108R-2 and UST116R/UST116R-F sub-surface
5: After the four steps, the each channel of VIDEO output of UST116R/UST116R-F is ready to work.
Check After Connection
1. Power On Red LED Indicator Light
2.Video Signal Present Yellow LED Indicator Light (UST101T UST104R-2 UST108R-2)
3. Make sure that every wire is correctly and firmly connected.
Dimensions no excluding BNC: Standard 19"1U (UST116R/UST116R-F)
3 Year Warranty