UST108R UTP CAT5 Video Receiver is an active (amplified) device that allows the extension of real-time monochrome or color video on up to 4000ft ,using Category-5 Unshielded Twisted-Pair (UTP) CAT5 networking wire. Baseband (composite, PAL/NTSC/SECAM) signals of any type are supported.
The unparalleled interference rejection and low emissions of the Model UST101T UST104T & UST108R allows long run video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the use of shared or existing cable plant. Ground-lifting ensures no annoying "hum-bars" when ground potential differences exist. With built-in lightning protection,transient protection, ESD protection,damaging voltage spike problems are eliminated.
Cable Distance：Up to 4000ft, UST101T(or UST104T)+UST108R UTP CAT5 or better
The transmission of real-time PAL, NTSC or SECAM video signals.
Image figure enhanced in output of UST104R Receiver.
Lightning protection, Transient protection, ESD protection, damaging voltage spike problems are eliminated
Dimensions no excluding BNC: 326X120X33mm
Frequency Response DC to 6 MHz
Distance Switch 4-Position Adjustable
for each channel.
Common-mode / Differential-mode Rejection 15KHz to 5 MHz 60 dB typ
Coax, female BNC 75 ohms.
UTP, Terminal Block 100 ohms
Network Wiring 2 Unshielded Twisted Pair 24-16 AWG (0.5-1.31mm)
Category Type Cat 5 or better
Impedance 100 ± 20 ohms
DC Loop Resistance 52 ohms per 1,000 ft (18 ohms per 100 m)
Differential Capacitance 19 pF/ft max (62 pF/m max)
Power On Red Indicator Light
Power Supply Range
Transmitter/Receiver: DC/AV 9-12V 500 mA MAX (24VAC/DC)
9-12V AC/DC (MAX 24V AC/DC)
Temperature 0°C to +50° C
Humidity (non-condensing) 0 to 95%
6,000 V 1.2μS x 50 μS per ANSI/IEEE 587 C62.41 B3
.3,000 V 8μS x 20 μS when ground screw terminal is bonded to earth-ground
1:Put the video signals you need in the VIDEO IN of UST101T (or UST104T).
2: Put a twisted-pair in the each channel VIDEO A, B of UST108R.
3: Connect with the mains following instructions shown in the sketch map, make sure that the power should be between DC/AC 9 to 24V. Recommend work in DC 12V.
Recommend to share 12V DC power supply with camera in transmitter termination.
4: Set the position of ADJ correctly according to the distance table in UST101T(or UST104T) & UST108R sub-surface
5: After the four steps, the VIDEO output of UST108R is ready to work..
Check After Connection
1. Power On Red LED Indicator Light
2.Video Signal Present Yellow LED Indicator Light (UST101T UST104R-2 UST108R-2)
3. Make sure that every wire is correctly and firmly connected.
Dimensions no excluding BNC 326X120X33mm
3 Year Warranty